[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
(usagi-users 03660) Problems with stateless autoconf tests ...
- To: usagi-users@xxxxxxxxxxxxxx
- Subject: (usagi-users 03660) Problems with stateless autoconf tests ...
- From: Heiko Gerstung <heiko.gerstung@xxxxxxxxxxx>
- Date: Fri, 12 May 2006 11:26:12 +0200
- Organization: Meinberg Radio Clocks
- Reply-to: usagi-users@xxxxxxxxxxxxxx
- User-agent: Mozilla/5.0 (X11; U; FreeBSD i386; en-US; rv:1.7.7) Gecko/20060511
Hi!
I tried to run the IPv6ready test suite for Phase 1 (from TAHI) on a
Usage Kernel 2.6.15 (snapshot 2006/03/27 IIRC). Everything went fine
until it started to go into the Stateless Autoconfiguration section,
where all tests I tried out failed (well, I stopped after test 4).
It says:
reboot_async.rmt returned status 0
*** Target testing phase ***
Clear Captured Packets (Link0)
TN received no DAD NS sent from NUT. It seems that NUT doesn't perform DAD process.
Wait 5 second
Check if NUT's address is configured
Send DAD NS from TN to NUT: DADNS_from_TN_SameTgt
send DADNS_from_TN_SameTgt
Wait DAD NA from NUT: DADNA_from_NUT,DADNA_from_NUT_woTLL
recv DADNA_from_NUT
Received packet count=1
Received DAD NA from NUT: DADNA_from_NUT
NUT assigned the address to the interface.
Without DAD, NUT assigned the address to the interface.
NG
*** EOT ***
-> FAIL
I am pretty sure this is a configuration issue. What kind of
configuration do I have to set up in order to pass these tests?
Thanks in advance,
kind regards,
Heiko